Quote
Josh Wimpey
Robert, I saw on FB that you think that the mk4 spindles result in less offset than the mk2 spindles and this makes up for at least part of the 3/4" spacing. Do you have any photos showing the difference in the wheel mounting face with the mk2 vs mk4 setup? A spindle & bearing assembly with rotor flat on the ground would give you the measurement.

I have held them both in my hands and don't remember seeing much difference in assembled height/depth. but never checked.

That comment was made from memory, but I can get a flange to flange measurement this weekend (possibly) to verify.

I'll check my photogs and see what I can dig up as well.

So I still haven't gotten around to measuring the track difference....

But! I did find a list on Summit of 12 and 14mm studs that have a knurl diameter over 14mm. This will make it easier for those that want to use a 4X100 pattern.

-Drill out one of the threaded 14mm holes (I'd use the one opposite the small threaded hole that's used to hold the disk on) with the correct size drill for the knurl on the stud.
-Bolt the hub to a 4x100 wheel, using the one new stud location.
-Use a transfer punch or a drill guide to mark the other 3 hole locations. The small threaded hole should also be the center of one, FYI.
-Drill the 3 remaining holes with a drill press.

12mm Studs @ Summit
14mm Studs @ Summit
14mm EMPI Studs @ JBugs @ Amazon

New order placed at the machine shop. I'll have another 10-sets for sale in about 6 weeks.

Just in time for NEFR. I'd like a set please!

Please put me down for a set. I can send payment immediately.

Any updates?

Machinist started on them this last weekend.

I picked up the new batch of adapters this weekend.
I'll be ordering hardware on Monday, and I'll be able to ship them as soon as the hardware shows up.

8 sets left and ready to ship!

Robert, What is the part number for the 4x100 Caddy hubs that fit the mk4 rear spindles?

And, where do we send money?

---

____________________________________________________________-

One. Class -- 2WD

www.quantumrallysport.com

http://www.facebook.com/home.php?#/pages/Quantum-Rally-Sport/281129179600?ref=nf

I guess that would make it a bit easier

From William Marenichs wonderful reasesrch : vw 6K9 501 477

Send money to mr.robert.culbertson at gmail dot com.

Bump. I still have at least 6 sets to sell.

Robert, if you have any left, I'd be up for a set or two. I'm building a Mk. II next year, and since my other two cars are Mk. IV's, this would allow for much less spares.

Would these allow for a 5x100 disc brake conversion on the rear?

Quote
DanielSL
Robert, if you have any left, I'd be up for a set or two. I'm building a Mk. II next year, and since my other two cars are Mk. IV's, this would allow for much less spares.

Would these allow for a 5x100 disc brake conversion on the rear?

I could ship them out next week.

And yes, it allows a standard mk4 rear brake/hub/stub to be bolted onto a mk1/2/3 rear beam .

Pay no mind bumping the Spammer threads down

---

................................................. .....................

Support your Local North American Rally Forum!!

While they are still around-and get the hell off Farsebook!!

We still have Specialstage & RallyAnarchy.

Post up Here:

https://rallyanarchy.com/phorum/posting.php

and here:

https://www.specialstage.com/forums/forum.php